Stump One-Man Window Assembly Instructions

Parts

4-Tinted Windows
36-#6 Lock Nuts
8-Hinges
32- #6-32 x 2" truss head bolts
4-Wing locks w/screws

Tools

Cordless drill with Phillips bit
5/16" socket or wrench

1. Separate out your pieces of your window kit.  Take one window and face it down on the drip edge. 
2. Take one hinge and on the square side of the hinge line it up below the holes of the window edge.  Take two of your truss head bolts, from the bottom up push it through the aligned holes of the window and the hinge.  Tighten the bolt to a snug fit. Do not over tighten.
   
3. Repeat steps 1 and 2 on the second hinge for that same window.
4. After both hinges are bolted to the window take the window to the inside of your Stump and center it in the window cut out. Make sure none of the drip edges are touching a sidewall. Take a 3/16” drill bit and drill out two holes per hinge into the stump wall itself.
   
5. Insert a bolt and tighten to a snug fit.  Do not over tighten!  Limit to two bolts per hinge
6. After the window is completely attached to the stump and swings open properly, then you need to apply the "wing locks".  These are easily assembled to the stump.  They are put in the middle of the window opening opposite the side of he hinges of the window.  Close the window and place the wing lock against the window and the stump.  Determine where it would best be suited for easy twisting to allow the window to open and lock properly.  Take the self-tapping screw and screw it into the stump.  The tightness of the wing lock is determined on how tight you screw in the self-tapping screw.  There is one wing nut for each corner of that side of the window.
   
7. Your window is finished!
   
8. Repeat Steps 1-5 to remaining windows. 

Any questions please give us a call at 800-262-4129 M-F 8-5!

Back to Stump One Man