Stump 3-Man Window Assembly Instructions

Parts

Click here for a printable version

8-Tinted Windows
16-Hinges
64-#6 Lock Nuts
64- #6-32 x 1/2 " truss head bolts
16-Wing locks w/screws

Tools

Cordless drill with Phillips bit
5/16" socket or wrench

• 1. Separate out your pieces of your window kit. Take one window and face it down on the drip edge.
• 2. Take one hinge and on the square side of the hinge line it up below the holes of the window edge. Take two of your truss head bolts, from the bottom up push it through the aligned holes of the window and the hinge. Tighten the bolt to a snug fit. Do not over tighten.
  
• 3. Repeat steps 1 and 2 on the second hinge for that same window.
• 4. After the hinges are bolted to the windows take 4 of the windows and put the weather stripping on the side opposite of the hinges.
  
  
  5. Then take your windows and attach them to the Stump and match them up to the pre-drilled holes in the sidewall. Make sure you use one window with weather stripping and one without weather stripping to fill one double window opening.
• 6. Insert a bolt and tighten to a snug fit. Do not over tighten! Limit to two bolts per hinge
  
• 7. After the window is completely attached to the stump and swings open properly, you then need to apply the 'wing locks'. These are easily assembled to the stump. They are put in the top corners of the window opening opposite the side of the hinges of the window. Close the window and place the wing lock against the window and the stump. Determine where it would best be suited for easy twisting to allow the window to open and lock properly. Take the self-tapping screw and screw it into the stump. The tightness of the wing lock is determined on how tight you screw in the self-tapping screw. There are two wing locks for each window.
  
• 8. Your window is finished!
  
• 9. Repeat Steps 1-5 to remaining windows.